Steel installation safety precautions
1. When working at height, do not stack the steel bars, and do not throw the tools on the scaffolding at will, so as not to slide down.
2, manual handling of steel must be equipped with good gloves, multi-person transport of steel, landing, turning, stopping movements must be consistent, manual transfer up and down must not be on the same vertical line.
3. Lifting the steel frame with a crane, it is necessary to be tied by the sergeant. The steel bar is strictly forbidden to participate in the lashing. The hoisting work is carried out. When lifting, the station is forbidden. The steel bar must be placed close to the ground to support the rear. Can be hooked.
4. The operating platform (scaffolding) and the passage must be erected in the suspension beam and deep foundation pit tying and installing steel bars.
5, tying up the column, wall reinforcement, not standing on the steel frame or climbing the top and bottom of the skeleton; within 4 meters, the weight of the column is not large, can be erected after the ground is tied; 4 meters above the table should be set up, column beam The skeleton should be temporarily supported and pulled to prevent dumping; the square wooden frame should not be used on the column bars to prevent falling accidents.
6. When tying the foundation steel bar, the steel bar bracket or the horse stool frame should be placed according to the construction requirements to lift the upper steel bar. Do not arbitrarily reduce the bracket or the horse bench.
7. It is not allowed to stack steel raw materials, semi-finished products and finished products on the outer scaffolding and the edge of the hole. It is strictly forbidden to pull the steel bars on the scaffolding.
8. When the construction site is tied with steel bars, always pay attention to the equipment, switch boxes, power lines and personnel of the site to prevent the steel bars from hurting others and the transport parts of the equipment, and causing accidents when touching the live parts.
9. Do not throw any materials up or down in high-altitude operations to prevent accidents caused by others.
Recommended article: "Safety Considerations for Steel Bar Processing" http://
Finger spinner is make with high speed bearings and quality plastic, ABS material. With Green, Blue, Black,Red and White color for choising.
Finger Spinner,Hand Spinners,Toy Spinners,Popular Finger Spinner
Ningbo Borine Machinery Co.,Ltd. , https://www.borine-agroparts.com