How to install the door
Door installation user instructions
1. It is strictly forbidden to touch, step on, drop, or smash the door when it is moved, hoisted or transported.
2, the door is interior decoration door, the product can not be exposed to the sun, prohibit fire, roasted.
3. The door is a complete finished product. Saw, planer and other reprocessing are strictly prohibited.
4, the door is a category of wood products, have a certain degree of moisture resistance, can not be rain, water immersion, damp.
5, the door is strictly prohibited with a blade, glass and other sharp touch, scratch the surface.
6, the door can not have other acid-base chemical pollution, damage the surface.
7. After the product is installed, the house should be well ventilated. Never close the doors and windows to prevent the door from absorbing moisture.
installation method
1. The installation of the paint-free indoor door must adopt the method of installing after the reserved hole. It is forbidden to install the edge of the door or install it first and then install it.
2. The paint-free indoor doors must be installed after the groundwork and paint operations are completed.
3, install the door frame
(1) On a smooth and clean floor, use a 2.5mm diameter drill to draw a 30-40mm deep hole in the mullion, and use 4 60mm nails to attach the horizontal frame to the two mullion frames. The three boxes are on the same plane; the horizontal box and the mullion are connected at an angle of 90 degrees.
(2) Fix 6-8 pieces of fixed pieces on the sides of the mullions with wooden screws, turn the assembled door frames “upside down†on the ground, and fix the other 6-8 pieces with wooden screws. In the side of the mullion, nails "locking feet" and "locking corners".
(3) "Pre-combining" the door leaf with the door frame (with mining side). It is required that the gap between the door leaf and the door frame be even and reasonable.
4, frame and wall joint fixation
(1) Push the whole assembled door frame into the entry hole. Use a plumb bob to check if the entire frame is perpendicular to the plane.
(2) Using the hole of the fixed piece as a point, determine the drilling point on the wall.
(3) Drill a hole with a diameter of 8-10mm in the set hole, drill a wooden wedge in the hole, and fix the door frame to the wall with the nail.
(4) Inlaid wooden strips in the joint between the fixed door frame and the wall body, so that the door frame is firmly connected with the wall body.
5, install the door
(1) Drilled page slot, drill keyhole, lock plate seat, lock tongue buckle. The trim surface shall not be manipulated during the drilling operation.
(2) Installation is complete. The center of the upper and lower hinges is 300mm from the upper and lower ends of the door leaf. Before nailing the wood screw, first nail the eye, then nail the wood screw and tighten it. Twist a screw on the upper and lower hinges. Then close the door to check if the gap is appropriate. Check whether the door frame and the fan are in the same plane. Whether the door leaf falls or not, tighten the other screws. It is forbidden to "drive" the screw directly into the door leaf frame.
(3) Install the door lock. The lock position is 920mm from the lower end of the door leaf; after the door lock is installed, pay attention to comprehensively check whether the door leaf door lock switch is flexible and whether the left joint is suitable.
>>>Links: Benefits of the Paintless Door
Door and window acceptance paint decorative glass switch house glass door
In the clinical medical experiments usinghuman venous blood as specimensome take the serum from the specimen as the experimental object.The blood collection tubes suitable for this type of medical tests are called serum blood collection tube.
color guide blood collection tubes,collection tubes for blood,tubes for blood collection,blood collection tubes color code
Yong Yue Medical Technology(Kunshan) Co.,Ltd , https://www.yypcrtube.com