Built-in 7 sensors Japan Honeywell launches new module products

2024-06-06 10:05:38
Honeywell Japan (Headquarters: Tokyo) will launch the compass sensor module "HCS01" with 7 sensors including 3-axis magnetic sensor, 3-axis acceleration sensor and air pressure sensor in one package in April 2007. . If a temperature sensor for correcting the temperature of the internal sensor is added, as well as an external humidity sensor as an option, then 9 sensors can be used on one interface. The package size is 6 x 6 x 1.2 mm. Compared with when it is embedded in different packages, it can not only reduce the installation area and power consumption, but also improve the usability. Suitable for mobile phones, portable navigation devices and driving posture control.
The AMR (Anisotropic Magnetoresistive) magnetic sensor built into the compass sensor module HCS01 can perform an action for eliminating the influence of the magnetic sensor offset and temperature drift alone. Thereby, miniaturization and low power consumption are achieved. The acceleration sensor is used to detect the acceleration of gravity and determine the tilt angle of the sensor module. On this basis, the output of the magnetic sensor is corrected, thereby ensuring that the correct orientation can be calculated in all poses. The air pressure sensor detects the atmospheric pressure of the environment in which the sensor is placed. The height can be obtained by comparison with a preset reference value. It can even be used to predict weather based on changes in pressure data over time.
The maximum measurement range of the magnetic sensor is ±600μT. This range is equivalent to about 12 times the Japanese standard geomagnetism. The maximum measurement range of the acceleration sensor is ±2G. The measurement range of the air pressure sensor is 710 to 1062 hPa で, and the measurement range of the temperature sensor for calibration is -20 to +80 °C. The sample price is $40 and the post-production purchase is $10.

CBN Cutting Discs

CBN abrasive is mainly used for steel parts, such as high speed steel, die steel, 45 steel, etc., can be made into electroplating CBN, resin CBN, sintered CBN. Can be made into grinding wheel, cutting pieces, grinding head. Abrasive sharp, high temperature resistance, good thermal stability, wear resistance. The hardness of CBN is higher than that of ordinary abrasives and the ability to maintain shape is one of the main characteristics of high performance abrasives. CBN is very resistant to pressure. CBN has good thermal conductivity and can achieve cold cutting during grinding.

strong wear resistance, long life

The grinding ratio of CBN wheel can reach 3500-5500, which is 100 times higher than that of ordinary corundum wheel and 3-5 times higher than that of diamond wheel.

environmental protection, no pollution, energy saving and consumption reduction

No too much powder dust.

High work efficiency and good comprehensive economic benefits

The grinding is sharp, the grinding force is small, the dressing cycle of CBN wheel is long, the dressing amount is less, and the replacement time is long. Long service cycle, high grinding ratio, can obtain better economy, good shape retention in use, do not need to change and trim grinding wheel often, save working hours, improve working conditions, is conducive to machining operation.

Cubic boron nitride is not suitable for grinding hard metals and non-metallic materials. At high grinding temperature, CBN will react with alkaline aqueous solution. CBN grinding wheel will decompose in alkaline solution at 300℃, and can decompose in trace amount in boiling water, which will destroy the crystal shape of grinding grains. Therefore, oily coolant should be used instead of water-based coolant during grinding.



Cbn Cutting Discs,Flap Disc,Grinding Disc,Cbn Cutting Blade

Henan Jinlun Superhard Material Co., Ltd , https://www.jinlunsuperhard.com