Track type shot blasting machine cleaning procedure
To ensure the safety of the operation process, the relevant operators of the track-type shot blasting machine must observe the following procedures:
1. Regularly inspect the various transmission departments, clean the parts, replace the worn parts, and cut off the power supply during the overhaul process. It is strictly forbidden to cut off the power supply for maintenance. If repairing is done by electric welding during the overhaul, first notify the equipment department to send someone to take care of it. And prepare fire-fighting equipment, wait until everything is ready before welding, and private welding is strictly prohibited.
2, the projectiles are added to the drum according to the specified amount, and then put into the product, close the blasting chamber door, and it is strictly forbidden to start the door without closing the door.
3. Adjust the shot blasting time relay to the selected shot blasting time, start the hoist in sequence, rotate the drum forward, blasting machine, dust collector, and prohibit the order from being reversed.
4. Depending on the working conditions, the dust in the dust box below the dust collector should be cleaned regularly to prevent blockage of the dust exhaust pipe and affect dust removal and separation.
5. If abnormal conditions are found during operation, it is necessary to stop the inspection immediately. It is strictly forbidden to carry out the operation of the crawler type shot blasting machine.
6. The operator should operate the crawler type shot blasting machine. Be sure to read the relevant manual and attached materials carefully. It is strictly forbidden to operate by non-professionals.
In addition, the daily maintenance of the track type shot blasting machine should be paid attention to during use, so as to avoid damage to the operator caused by equipment failure.
The length of each cleaning of the track-type shot blasting machine may be due to:
1 The orientation of the orientation window is incorrect;
2 blasting machine inner guard plate, directional sleeve, splitting wheel, and blade wear are serious;
3 use the projectile too small;
4 The flow of the projectile is too small.
So to solve this problem, we need to take targeted measures.
1. Adjust the position of the opening of the orientation sleeve;
2, check each piece, if the wear is serious, it should be replaced immediately;
3. Choose the right projectile;
4. Adjust the electromagnetic valve to increase the flow of the projectile. If the projectile circulation is insufficient, the projectile should be added.
Http://news.chinawj.com.cn
Pneumatic Toilet Tank is a high-tech toilet equipment that uses pneumatic technology to control flushing. Compared with traditional mechanical hidden water tanks, it has higher flexibility and reliability.
The pneumatic toilet cistern is mainly composed of a water tank, an air gauge, a cylinder, a water valve and buttons. When the button is pressed, the air gauge will automatically release the compressed air into the cylinder, push the water valve to open and release the water into the toilet basin. When the air in the barometer is completely released, the water valve will automatically close, stopping the inflow of water.
The advantages of the pneumatic toilet tanks include: the amount of flushing water can be adjusted freely, the flushing effect is better, the service life is long, it is easy to clean, and it is more water-saving. It can control the amount of flushing water by adjusting the air gauge, so as to adapt to different toilet basins and flushing requirements. In addition, the pneumatic hidden water tank does not require any buttons or handles to be touched by hand, which also makes it more hygienic.
Pneumatic Toilet Tank, Pneumatic Cistern Flush, Sensor Toilet Tank, Automatic Flushing Cistern
Guangdong Fabia Intelligent Technology Co., Ltd , https://www.nbsmartfabiatoilet.com