Second-hand housing renovation guide: decoration optimization four steps
The second-hand house decoration has more unpredictable troubles than the new house decoration, and some places of the second-hand house decoration must be dismantled, and some cannot be moved. All these are stipulated. In other words, the decoration of a second-hand house will further test the ability of the homeowner to co-ordinate. Second-hand housing renovation can be divided into the following four steps:
Germany Kenuo Rhine sunshine
First, structural optimization
1, before the second-hand housing decoration, the old house renovation according to the actual situation of the house to carry out some structural layout optimization, the waste of space fully utilized;
2. Dismantle and renovate some partition walls (non-bearing walls), wall cabinets, top cabinets, etc. to increase and improve lighting and usage.
Second, waterway optimization
1, according to the shower, wash basins, toilets, washing machines, vegetable sinks, mop pool, water purifiers, electric water heaters, gas water heaters to increase the location of some inlet, outlet, drain outlet.
2. Replace the original old pipeline with a PPR pipe (preferably a PPR composite copper pipe) and replace it with a dark pipe.
3, the old valve is always closed, not only beautiful and not easy to use, it is best to replace the vacuum copper ball valve with reliable quality.
Third, circuit optimization
1. Many buildings in the 1990s had mixed a circuit between the lighting and the socket, and the wire was an aluminum core wire or a 1.5 square copper wire. When several electrical appliances or one of the electrical appliances was opened at the same time during use, The main gate jumped, resulting in the failure of normal use of other electrical appliances. In addition, the circuit of these old houses was not protected by grounding. It could not effectively prevent accidental damage to the human body caused by circuit leakage or short circuit leakage. !!!
2. Some of the old building's high-voltage systems The government had conducted capacity expansion at the end of the last century, but the capacity expansion is generally limited to air-conditioning circuits and can basically guarantee its use. However, most of these capacity-added cables are cable trunking or Walk directly on the outside of the wall with a three-phase sheathing line, which seriously affects the overall aesthetic appearance of the wall surface. These lines must also be transformed into dark lines.
3, these old houses; old house distribution box settings are generally older, the circuit is too simple, and the power ratio of each circuit is not reasonable, need to be based on the power of all the power equipment, planning a safe and reasonable Circuit design. In an ideal state, the switch box should be five switch circuits: master switch, lighting, common socket, air conditioner, kitchen and bathroom socket. If there is a fast-fired water heater, it is necessary to add a separate circuit of 6 square copper wire.
4. As more and more household appliances and lamps are used, there are many places where switches and sockets need to be placed. Before the renovation, we must do a good job of cabling work in advance, which places need to be placed in the future what electrical appliances, planning in advance, and the old house reserved switches and sockets are generally not enough.
In general, a room must have at least 3 outlets. There should be no fewer than 15 sockets in a two-bedroom residential building and no less than 8 switches. The switch height of the same room should be the same, generally the lower part of the switch is 1.4 meters away from the ground, and the lower part of the socket is 0.3 meters away from the ground. All the switches should be set in a convenient location.
Fourth, the overall reform of second-hand housing renovation:
First: There are many ways to improve the ground. The first is ground disinfection. To completely disinfect it, spray it with 3% lyosol, 1%-3% bleach water, or 3% peroxy acetic acid solution. Sprinkle doors and windows 1 hour after spilling.
Second: second-hand housing renovation wall issues. 90 years of the wall decoration popular spray. If you are hitting a spray wall, you have to shovel it back, clean the wall, brush the primer, and then brush the latex paint finish. If it is a wallpaper, it will be much easier.
The third way: The improved appearance of doors and windows can save a lot of money. You can continue to use the door of the owner of the original room, but you need to decorate it slightly. For example, if you add some lines to the original door, you can use the original door as a blank and change it. Beautify it. The simplest method is to paint the original door with beautiful colors.
Second-hand house decoration entrance decoration children's room decoration switch socket electrical paint room partition wall cabinet closet closet door
Led Stretch Spot Light,Stretch Spot Light,Led Surface Spot Light,Led Surface Track Spot Light
Foshan Brinno Technology Co.,Ltd , https://www.brinnolighting.com