Corrosion-resistant submersible sewage pump motor burn what are the reasons

[Asia pump network hearing] In the case of quality assurance, corrosion-resistant submersible sewage pump motor sometimes be burned, what causes this phenomenon? Below, Xiaobian for everyone to analyze the corrosion-resistant submersible sewage pump motor burn what are the reasons, I hope everyone in the course of a lot of attention to better protect the motor. The following four aspects to illustrate: Corrosion-resistant submersible sewage pump motor is what causes 1, the installation of the pump The installer did not pull the pump through the ring on the pump, but by pulling the pump into the water cable. Because the corrosion-resistant submersible sewage pump is completely closed, if you pull the cable, there will be damage at the cable seal, so that water into the pump, causing the motor to be burned. 2, excessive liquid particles, fibers, large debris corrosion-resistant submersible sewage pump can not transport sludge, debris, because the sludge, debris will make the pump block, resulting in burning motor. 3, Pump idling Because the corrosion-resistant submersible sewage pump is cooled by liquid, if the liquid level in the tank is lower than 2/3 of the pump body, the motor will be burned because the temperature of the pump body is too high. 4, overcurrent If the corrosion-resistant submersible sewage pump when using the super-current will cause burn the motor, common over-current situation is: the actual lift of the pump is much larger or smaller than the lift of the selected model, the liquid concentration is too large, three Phase current imbalance and so on. The above four kinds of situations are common causes of corrosion-resistant submersible sewage pump motor burning, which one should be based on the actual use of the situation to be excluded. Conversely, the user in the course of the use of these should be avoided as far as possible in order to protect the corrosion-resistant submersible sewage pump motor to extend its service life. Further Reading: motor top ten brands of Chinese architecture exhibition ptc water pump valves pipe fittings exhibition Exhibition Fair article belongs to the water industry interconnect (Xiamen) Co., Ltd. All are welcome to reprint, please indicate the source and author of: Asia Pump Network Editor: L (QQ / WeChat:) starting: http://beng.liuti.cn/ (service hotline:)

Basin Faucet

Basin Faucet,Wash Basin Faucet,Face Basin Faucet,Water Tap For Wash Basin

Heshan Janno Kitchen and Bath Technology Co.,Ltd , https://www.janno-ks.com