Commonly used route for machining parts on CNC lathes
2022-09-25 07:06:25
Commonly used route for machining parts on CNC lathes:
(1) Analysis of the path of the arc of the car
In the actual car arc, it is necessary to process multiple knives, first cut off most of the margin, and finally drive out the required arc. The following describes the machining routes commonly used for car arcs.
Figure 1 shows the step path of the arc of the car.
Figure 2 (a) shows the concentric arc path of the arc of the car.
Figure 3 shows the car cone cutting route of the car arc
That is to say, first a cone, then the arc.
(2) analysis of the path of the car cone
Next page
Phosphated Black Hex Nut Setter
nut setter,hex nut setter,magnetic hex nut setter,Phosphated black Hex nut setter,nut setter factory
henan horn tools co.,ltd. , https://www.horn-tool.com